stepside
Well-Known Member
Hello
has been a long time since the last time I wrote here
I started a new project, ford 39 standard
frame and body are badly rusted, so i made new frame
Longitudinal leaf springs in rear and stock front axle with coil springs and four link
I was lucky and found chrysler 331 hemi engine and plymout od gearbox
Engine is good condition crank and bearings are like new
There is small sholder in the cylinders but i hone cylindes and rering engine
I found hemi flywheel ,piston rings and lifters in old speedshop in sweden cost 160€ that was cheap
Body is under the snow so i dont have pictures but it is badly rusted so i weld new floors
has been a long time since the last time I wrote here
I started a new project, ford 39 standard
frame and body are badly rusted, so i made new frame
Longitudinal leaf springs in rear and stock front axle with coil springs and four link
I was lucky and found chrysler 331 hemi engine and plymout od gearbox
Engine is good condition crank and bearings are like new
There is small sholder in the cylinders but i hone cylindes and rering engine
I found hemi flywheel ,piston rings and lifters in old speedshop in sweden cost 160€ that was cheap
Body is under the snow so i dont have pictures but it is badly rusted so i weld new floors
Last edited: