Went to change the fluid and filter in the TH400. I noticed that the fluid running over the pan into the catch can was bright red and very transparent with the bright sun's light in the background, I'm thinking it's too clean.
When I removed the pan I noticed the filter was hanging but the bolt holding the filter was tight. I don't think the filter was catching the fluid. It wasn't connected to the return tube. The nut you can see in the photo is in place and it has an unthreaded shank nearly 1/4" unthreaded. The hole for the filter is much too large for this bolt.
Also, there is some sort of sensor on the driver's side of the Trans (see photo) you can see what it is attached to on the other side. Anyway, that sensor has a brown or black wire with a tan colored tracer and the wire loops over the top of the Trans and stops there . . . . Not connected to anything. What is it and where should that wire go?
Is that filter hold down bolt the wrong one, if so is there any part number?
The first photo shows a silver oval casing on a 45 degree angle on the left side of the photo, it looks like a relay and has a red wire leading out to a sensor looking connection.
The 2nd picture shows the unplugged side of the sensor as mentioned about the 1st photo.
The next 2 pictures show the bolt that should have held the filter "See the bolt next to the Teal colored #34 stenciled on the valve body"
When I removed the pan I noticed the filter was hanging but the bolt holding the filter was tight. I don't think the filter was catching the fluid. It wasn't connected to the return tube. The nut you can see in the photo is in place and it has an unthreaded shank nearly 1/4" unthreaded. The hole for the filter is much too large for this bolt.
Also, there is some sort of sensor on the driver's side of the Trans (see photo) you can see what it is attached to on the other side. Anyway, that sensor has a brown or black wire with a tan colored tracer and the wire loops over the top of the Trans and stops there . . . . Not connected to anything. What is it and where should that wire go?
Is that filter hold down bolt the wrong one, if so is there any part number?
The first photo shows a silver oval casing on a 45 degree angle on the left side of the photo, it looks like a relay and has a red wire leading out to a sensor looking connection.
The 2nd picture shows the unplugged side of the sensor as mentioned about the 1st photo.
The next 2 pictures show the bolt that should have held the filter "See the bolt next to the Teal colored #34 stenciled on the valve body"
Attachments
Last edited: