I have the motor and trans in the frame and motor mounts fitted but not tacked in. I hope to get that done today then get rear end located. It’s a little different order to do it that way but I think motor placement is very important to the look I’m after and I can pretty much put the rear end anywhere I need to as long as my drive shaft angle is good. Right now the trans output shaft is exactly the height of the centerline of the rear wheel centerline so moving the frame height up a minimum amount will keep undoing angles close to 2*.
Project is looking good! As for the tank and regulator... could you take one off a gas grill? I see old grills along the curb alot when I venture into town.
Some even have the tanks with them.
Waiting on the rear suspension and brake parts to get here. Got the motor and trans mounted and the firewall cut out and templates for floor cut out. Only had to make 1 pattern. Flip it over and it work