This may be an off the wall question, but here goes:
I'm building my 1968 VW Bug for the Silver State Classic (95MPH Class), and the USFRA 130MPH Club. The car will be running a 2052cc Turbocharged engine.
The original tubes for the clutch and throttle cables inside the VW Chassis are rusted out, so I'm going to use an hydraulic clutch and I'd like to use an electrically/electronic controlled throttle.
Does anyone produce a generic Drive-by-Wire Throttle Pedal/Carburetor Actuator Assembly that I can adapt to the dual Weber carb setup on my engine?
I've already talked to Lokar without any luck.
I'm building my 1968 VW Bug for the Silver State Classic (95MPH Class), and the USFRA 130MPH Club. The car will be running a 2052cc Turbocharged engine.
The original tubes for the clutch and throttle cables inside the VW Chassis are rusted out, so I'm going to use an hydraulic clutch and I'd like to use an electrically/electronic controlled throttle.
Does anyone produce a generic Drive-by-Wire Throttle Pedal/Carburetor Actuator Assembly that I can adapt to the dual Weber carb setup on my engine?
I've already talked to Lokar without any luck.