I just don’t get it and it’s getting out of hand with doing it over and over still leaking.
1. Yes I put a steel straightedge that is true, to the trans surface in many directions and it’s flat. Same for the factory pan.
2. Used Felpro gaskets and one expensive specialty maker gasket.
3. Torqued to factory specified limits.
4. Tried increasing torque 15%
5. Checked for leaks around sensors and linkages that could run fluid down and collect around pan lip before dripping off.
It still leaks! What kind of sealant can be used? Maybe I can weld it together . . . . .
1. Yes I put a steel straightedge that is true, to the trans surface in many directions and it’s flat. Same for the factory pan.
2. Used Felpro gaskets and one expensive specialty maker gasket.
3. Torqued to factory specified limits.
4. Tried increasing torque 15%
5. Checked for leaks around sensors and linkages that could run fluid down and collect around pan lip before dripping off.
It still leaks! What kind of sealant can be used? Maybe I can weld it together . . . . .