Carlos
Active Member
Hi,
a buddy has the LONG HN-1000 shifter attached to his Ritchmond 5 speed.
It is the second time now where the two little parts, I'd call them "spring plates", holding the shifter in the center position, became saggy. The shifter has no clear center any more, so shifting is a pain and requires patience. Not what you want in Cobra powered by a bad Cleveland ;o).
We couldn't find a source for these parts, the manual or assembly instruction don't show them at all.
Before buying the third shifter I am thinking about doing some testing with laser cut sheet metal.
Any hint or source aprecciated!
Thanks
Carlos
a buddy has the LONG HN-1000 shifter attached to his Ritchmond 5 speed.
It is the second time now where the two little parts, I'd call them "spring plates", holding the shifter in the center position, became saggy. The shifter has no clear center any more, so shifting is a pain and requires patience. Not what you want in Cobra powered by a bad Cleveland ;o).
We couldn't find a source for these parts, the manual or assembly instruction don't show them at all.
Before buying the third shifter I am thinking about doing some testing with laser cut sheet metal.
Any hint or source aprecciated!
Thanks
Carlos