needs bullet proof engine mounts

[Grumpy]

1. I'm plagued with a heavy throttle foot and a standard trans therefore it seems my motor mounts tend to tear.
   I have run the interlocking mounts for years and am not keen on the solid mounts.
   Are there any suggestions on gorilla tough mounts or should I just stop and go with solid mounts.
   I'll need the mounts to fit 2 5/8 wide stands and be 1 3/4 tall for my 496 '68 Camaro with steel SS hood.
   

   We took out the LT one from the impala changed out everything from original motor , and are installing another LT onebolts from a corvette , thing is the drivers side engine mount bolts up , bell housing bolts together , and everything lines up except the passenger side motor mount is about an inch to inch and quarter offset from even coming close to mounting up any Ideas can I flip it over and get mount to work ?????

   
   
   
   are you using the motor mounts on the engine your installing, in the impala from the impala original engine or from/ that came with the corvette,s engine, that came with that new replacement engine?
   https://www.autozone.com/collision-body-parts-and-hardware/motor-mount/chevrolet/impala
   
   https://www.classicindustries.com/shop/all-years/chevrolet/impala/parts/engine/engine-mounts/
   
   
   
   
   
   
   
   
   http://garage.grumpysperformance.co...urrent-flow-grounds-and-more.3504/#post-54625
   
   http://garage.grumpysperformance.co...hooting-tip-for-electronics.11317/#post-51557
   
   
   
2. 
   Grumpy
   http://garage.grumpysperformance.co...rque-straps-and-motor-mounts.2617/#post-40776
   
   http://garage.grumpysperformance.co...nts-adapters-brackets-sources.498/#post-19317
   
   http://garage.grumpysperformance.co...orque-straps-and-motor-mounts.2617/#post-6756

starter support brackets can be helpful
396588 = BB or Caddy
3965589 = 168 tooth SB '66-'91
354353 = 153 tooth '66-'91
3851294 = '64-'69 Vette
3816511 = '62-'68 SB

Attachment: brackets.jpg (53.42 KB) 4 View(s)