all 93-96 Corvettes have PKE factory fitted.
Here is some info for you on the functions of this system:
http://www.digitalcorvettes.com/forums/ ... hp?t=95531
To program the system:
1. Place transmitter and any optional transmitter 10 feet or more away from the car.
2. Turn the ignition key to the ON position and make sure the radio is OFF.
3. Push the TRIP/ODO button on the DIC twice.
4. Within 5 Seconds, push and hold the FUEL/INFO button on the DIC until the PKE light on the DIC comes on and stays on.
5. Turn the ignition to the OFF position, but leave the key in the ignition. The PKE light will come on and begin flashing.
6. Bring one transmitter into range. When the system recognizes the transmitter, the PKE light will stay on.
7. To program an optional transmitter, move the first transmitter out of range and repeat step 6
8. Remove the key from the ignition or turn the ignition ON.
To run a diagnostic test on the system:
Connect pins 4 and 8 on the ALDL (see pic below to see pin label order)
http://i11.photobucket.com/albums/a185/ ... lc19xs.jpg
And the PKE diagnostic system works as follows:
With pins 4 and 8 connected, the PKE light in the Driver Info Centre will flash the codes.
Here is the list of DTCs and what they mean:
DTC #12: Receiver Memory Bad
DTC #13: Transmitter Not in Range
DTC #14: Non-Valid Transmitter Received
DTC #15: Valid Transmitter Received
DTC #16: Passenger Door Button Depressed
DTC #17: Hatch Button Depressed
Here is some info for you on the functions of this system:
http://www.digitalcorvettes.com/forums/ ... hp?t=95531
To program the system:
1. Place transmitter and any optional transmitter 10 feet or more away from the car.
2. Turn the ignition key to the ON position and make sure the radio is OFF.
3. Push the TRIP/ODO button on the DIC twice.
4. Within 5 Seconds, push and hold the FUEL/INFO button on the DIC until the PKE light on the DIC comes on and stays on.
5. Turn the ignition to the OFF position, but leave the key in the ignition. The PKE light will come on and begin flashing.
6. Bring one transmitter into range. When the system recognizes the transmitter, the PKE light will stay on.
7. To program an optional transmitter, move the first transmitter out of range and repeat step 6
8. Remove the key from the ignition or turn the ignition ON.
To run a diagnostic test on the system:
Connect pins 4 and 8 on the ALDL (see pic below to see pin label order)
http://i11.photobucket.com/albums/a185/ ... lc19xs.jpg
And the PKE diagnostic system works as follows:
With pins 4 and 8 connected, the PKE light in the Driver Info Centre will flash the codes.
Here is the list of DTCs and what they mean:
DTC #12: Receiver Memory Bad
DTC #13: Transmitter Not in Range
DTC #14: Non-Valid Transmitter Received
DTC #15: Valid Transmitter Received
DTC #16: Passenger Door Button Depressed
DTC #17: Hatch Button Depressed