the last time I did a trans pan gasket , install.I simply sprayed the gasket on both sides of the pan gasket, with copper coat spray, and installed it wet and clamped it down evenly
BTW I have on several occasions seen guys who complain about various oil leaks on valve covers and rear seals ETC.
Used, engine parts will have oil embedded deeply into the micro surfaces.
almost all replacement parts will have a wax or grease preservative coating to prevent corrosion during shipping!
IF YOU simply wipe off oil soaked surfaces with a paper towel, who then smear on the sealant of there choice and proceed to install gaskets,
YOU WILL OCCASIONALLY HAVE LEAKS!
and then they wonder or maybe be in shock when you find the seeping oil leak has returned in a few weeks time!
metal surfaces may look smooth as glass but under a microscope they look like the surface of the moon , with lots of jagged surface cracks, so you really need to wash out the micro lubricants trapped in those cracks with a thin fast evaporating grease solvent and a lint free rag , followed by a second repeat of the process and in many cases a few minutes with a heat gun to dry and evaporate the solvent in the micro cracks ,
STOP AND READ THE SEALANT PACKAGE DIRECTIONS!
you'll generally find some rather amazing , bits of info such as temperature requirements, temperature limitations, what solvents work best to remove the cement or sealant, only after reading the directions, do you then smear the gasket sealant on both mating surfaces before bonding the two gasket & metal surfaces.(and in many cases you use a brush as dirt or oil on fingers prevents a good seal!)
pontiac
http://www.boxwrench.net/specs/pont_265-455.htm
chevy sb
http://www.boxwrench.net/specs/chevy_sb.htm
chevy BB
http://www.boxwrench.net/specs/chevy_bb.htm
426hemi
http://www.boxwrench.net/specs/hemi_426.htm
383-440 mopar
http://www.boxwrench.net/specs/bchrys_B.htm
318-340-360 mopar
http://www.boxwrench.net/specs/schrys_A.htm
ford 429-460
http://www.boxwrench.net/specs/ford_429-514.htm
302-351 windsor ford
http://www.boxwrench.net/specs/ford_302_351W.htm
351 cleveland ford
http://www.boxwrench.net/specs/ford_351C.htm
352-428 ford
http://www.boxwrench.net/specs/ford_352-428.htm
youll occasionally find uses for a high temp rated silicone sealant
like ultra-copper that has about twice the temp tolerance of the common black RTV
In my experience, the black rtv works ok,
but the high heat gray or copper gasket sealant has always worked a bit better
I prefer this for most of the jobs where silicone type gasket sealants get used like intake gaskets and valve cover gaskets
http://garage.grumpysperformance.com/index.php?threads/sealants-and-threads.805/#post-71928