Setting up my Geerage!

87vette81big said:
I thought the Rehr Morrison Heads were done Bob ?
Fully Assembled.
You porting them now ?
no Rick and I cc'd them at his place, I have the short block done. I am gasket matching all the ports. going to do a little behind the valves and gonna match the exhaust ports to the headers, gonna gasket match the intake also.
 
Here is the work table with the steel top on it. It took all day to get it done had some buckling from the welding.
 

Attachments

  • work table 6.jpg
    work table 6.jpg
    116.5 KB · Views: 26
Ok I've been meaning to ask...why is there a concave or inward curved edge on the table?
having it there obviously took more effort than a strait edge opposite the other edge with the small upward lip?
 
busterrm said:
87vette81big said:
I thought the Rehr Morrison Heads were done Bob ?
Fully Assembled.
You porting them now ?
no Rick and I cc'd them at his place, I have the short block done. I am gasket matching all the ports. going to do a little behind the valves and gonna match the exhaust ports to the headers, gonna gasket match the intake also.
Ok .
You will have Fun Bob.

Have made your engine & trans midplates like you want ?
I like the idea for your Nova.

I researched during the winter Midplating my old T/A.
Just 1 I found that might work with my car.
Takes the place of he block protecter plate in my McCleod Scatter shield.
Pretty expensive too.
Be nice to have it made. Acetylene table gas cut or CO2 Laser cut.
 
grumpyvette said:
Ok I've been meaning to ask...why is there a concave or inward curved edge on the table?
having it there obviously took more effort than a strait edge opposite the other edge with the small upward lip?
I did that so it would wrap around me some, take some weight off that outside, and put me closer to the work.
 
87vette81big said:
busterrm said:
87vette81big said:
I thought the Rehr Morrison Heads were done Bob ?
Fully Assembled.
You porting them now ?
no Rick and I cc'd them at his place, I have the short block done. I am gasket matching all the ports. going to do a little behind the valves and gonna match the exhaust ports to the headers, gonna gasket match the intake also.
Ok .
You will have Fun Bob.

Have made your engine & trans midplates like you want ?
I like the idea for your Nova.

I researched during the winter Midplating my old T/A.
Just 1 I found that might work with my car.
Takes the place of he block protecter plate in my McCleod Scatter shield.
Pretty expensive too.
Be nice to have it made. Acetylene table gas cut or CO2 Laser cut.
I have the front mount made, will have to make the mid mount when get the mock up block and tranny case in the car.
 
Original and Kool idea on the Workbench Bob.
Look forward to your Front & Midplate and 400 sbc Rehr Morrison in your Chevy Nova.
Be a real strong runner and fast.
 
Back
Top