My rocker arms will be here Thursday. I can't order my push rods until I get my rocker arms mocked up so I can check my set up to see which length push rods I'll need. My question is, can I mount a head onto my block with one of the head gaskets that I'm going to use? I won't torque it down to spec. Just enough so I can check to make sure I have the correct geometry. I have a Comp Cams adjustable push rod and their light weight springs and a valve spring compressor tool so I have everything I need to check them properly.
Will doing this hurt the head gasket at all? I only ordered one set to use to assemble my motor.
Thanks, NYH1!
Will doing this hurt the head gasket at all? I only ordered one set to use to assemble my motor.
Thanks, NYH1!