Using a Proform pushrod length checker, I found my pushrods to be a bit short.
Using feeler gauges I determined them to me .040" - .045" short.
Do I conclude correctly that that is TOO short?
Myy pushrods are 7.205" long.
Comp Cams offers the 5/16" pushrod off the shelf in a 7.250" length.
That may put me .005" or so over on a cylinder or 2, but I would recon that to be
considerably better than .040" short....(?)
Using feeler gauges I determined them to me .040" - .045" short.
Do I conclude correctly that that is TOO short?
Myy pushrods are 7.205" long.
Comp Cams offers the 5/16" pushrod off the shelf in a 7.250" length.
That may put me .005" or so over on a cylinder or 2, but I would recon that to be
considerably better than .040" short....(?)