An Option On A Source For Cranks Etc.

Discussion in 'Rotating Assemblies' started by Grumpy, Jan 22, 2021.

  1. Grumpy

    Grumpy The Grumpy Grease Monkey mechanical engineer. Staff Member

    just pointing out a few component options
    A couple local guys suggested using these
    cranks and rods, I have looked over a few and the
    quality looks decent, but I have no personal experience,
    using the components YET.


    https://www.molnartechnologies.com/

    https://www.molnartechnologies.com/domestic-crank-shafts/

    https://www.molnartechnologies.com/24367-2/

    IVE used SCAT rotating assemblies for decades
    from the limited selection I've seen on the MOLNARTECHNOLOGIES
    they look
    comparable to scat and better than EAGLE


    https://www.scatcrankshafts.com/


    related threads
    http://garage.grumpysperformance.com/index.php?threads/types-of-crankshaft-steel.204/

    http://garage.grumpysperformance.co...-about-your-potential-dream-bbc-combos.14607/

    http://garage.grumpysperformance.com/index.php?threads/dynamic-vs-static-compression.727/
     
    Last edited: Jan 22, 2021

Share This Page