When I tried to measure the runner length in the Edelbrock RPM Air Gap PN7501, I ran into a
problem. I called on the wife, she is really good a creative problem solving. In few minutes she
came up with the curved sewing needle, end of QTip and some wax to hold it. Dipped into some
paint and Wham Bam Thank You Mam I had a solution to marking the top side of the runner.
An interesting point ..... that intake runner came out exactly the same as the intake runner in the Brodix
heads. I thought I must have gotten confused when recording the results, but no I had the pics of
both measurements. It was not just the average that was exactly the same, but both measurements
for top/bottom sides.
I wonder if someone at either company is paying attention to the other ??????
problem. I called on the wife, she is really good a creative problem solving. In few minutes she
came up with the curved sewing needle, end of QTip and some wax to hold it. Dipped into some
paint and Wham Bam Thank You Mam I had a solution to marking the top side of the runner.
An interesting point ..... that intake runner came out exactly the same as the intake runner in the Brodix
heads. I thought I must have gotten confused when recording the results, but no I had the pics of
both measurements. It was not just the average that was exactly the same, but both measurements
for top/bottom sides.
I wonder if someone at either company is paying attention to the other ??????
Last edited: