snowmanmdp
Member
OK....I'm going to try this again, ordered the tpis gaskets to try this again....last time I could not get the back bolts :x Any suggestions are welcome.
Runner removal
- Thread starter snowmanmdp
- Start date
the harder to reach torx bolts youll want to access from the opposite side of the intake, those bolts require a long torx bit and swivel tool for reasonable access
http://www.harborfreight.com/cpi/ctaf/d ... mber=98484
http://www.harborfreight.com/cpi/ctaf/d ... mber=31203
be aware that the lower runner gasket is not interchangeable between the drivers and pass sides of the engine on a tpi and if installed incorrectly that results in hard starts a big vacuum leak and an engine that won,t idle
http://www.harborfreight.com/cpi/ctaf/d ... mber=98484
http://www.harborfreight.com/cpi/ctaf/d ... mber=31203
be aware that the lower runner gasket is not interchangeable between the drivers and pass sides of the engine on a tpi and if installed incorrectly that results in hard starts a big vacuum leak and an engine that won,t idle