What should i expect ??

55bowtie

55bowtie

Member
What can i expect with this combo?It's new and almost new parts i have right now and i was wondering what i would get .I have a 400 sbc with stock dish pistons with 4,000 miles on it.I have Sportsman 2 heads 64cc 2.02 and 1.60 stainless valves 200cc runners,harland sharpe 1.5:1 roller rockers .An elgin cam .453 int .480 exh lift 112 lobe ctrs sae dur 282 int 294 exh and new lifters.It has a weiand stealth intake with 600 edelbrock. headers with mufflers with 2 1/2 in exhaust pipes. a tci street fighter 350 trans with a 2000 stall and 3.08 posi .It's all in a 55/56 pickup.I drive it alot and go to a lot of show and shines out of state .MPG is not important.I like to open it up once in a while and do a burnout every so often.I don 't know what the truck weighs.What should i expect.Whats wrong/or right /oroverkill? THANKS MIKE
 
http://www.elgincams.com/c-che2.html

I don,t see that elgin cam listed
but without running it thru a software dyno, because I don,t have exact compression, cam specs etc. Id be looking for about 310-320 rear wheel hp
the one rather obvious upgrade you could make is going to a 3.73-4.11 rear gear ratio and swapping to a 200r4 or 700r4 overdrive transmission, or at least to that type rear gear ratio and a 3000 stall converter in the current trans.

http://www.tciauto.com/Products/TechInfo/trans_dims.asp
 
You must log in or register to reply here.
Back
Top