JimmyDuncan
Well-Known Member
Here's a few pics of my Rochester 2GV carburetor.
The driver's side.
Note the remains of the choke pull-off and the large tube poking out, that has an ugly hose clamped plug on the end.... What was that usually attached to?
The attachment spot on the intake for the divorced choke thermostat spring is visible on the left in this pic
Here is the back view with the choke pull-off.. It was plastic and just fell to bits when I bumped it... Also, the plugged vacuum port at the bottom. Again, what's that pipe heading off to the right for?
And the top view.... Is there anything that can be done to fix/hold together that crack in the air-cleaner stud hole? It seems to be holding on for now, but every time I tighten the air cleaner, I expect it to pull the stud out....
The driver's side.
Note the remains of the choke pull-off and the large tube poking out, that has an ugly hose clamped plug on the end.... What was that usually attached to?
The attachment spot on the intake for the divorced choke thermostat spring is visible on the left in this pic
Here is the back view with the choke pull-off.. It was plastic and just fell to bits when I bumped it... Also, the plugged vacuum port at the bottom. Again, what's that pipe heading off to the right for?
And the top view.... Is there anything that can be done to fix/hold together that crack in the air-cleaner stud hole? It seems to be holding on for now, but every time I tighten the air cleaner, I expect it to pull the stud out....