You have the gaps in the door panels because screws are missing, never installed. Missing the factory dimpled screw holes top and bottom means they are not OEM...
Oh definitely! Willcox, Zip, Ecklers, Mid America, Paragon, Corvette Central and a few others sell them. You will also find those fasteners under the interior side of your tee top panels and behind the “A” pillar interior plastic trim. The plastic shrinks a little therefore loosing their ability to interlock securely.FANTASTIC, Chrome !!!
Thanks for all this great information.
Those friction fit fasteners do not seem to work at all. Seem like primitive Velcro. Should they be replaced?
The plastic shrinks a little therefore loosing their ability to interlock securely.
Thanks!! I will replace them all. (None of them seem to work)
I need to find out if they have those missing screws as well. SHOCKED that they were not installed.
Can the door panel be "un-warped" by placing in hot water? Not much sun over here...
Good job. See you went with stripping everything off the motor. Yes, if you don’t have a 2ton lift the reach may fall a little short compared to the 1 or 1.5 ton lifts. How did the clutch look?