So I came out to tinker today with a new set of coilovers I got for christmas and I ran into my first problem.
I installed a new detroit speed swaybar into the front of my 4thgen camaro. Im getting ready to install Coleman hubs and swap the front bushings for poly as well. Apparently, the bar was not made considering I might be using brackets to upgrade my front brakes because it causes a serious interference problem.
While it appears that I could bring out the grinder to modify the bracket and swaybar to fit better, I think a better solution would be to use a longer endlink...If I webt 1 1/2 inches longer there would be no problem.
This is an adjustable bar...it uses c5 style end links. It uses the flats cut into the end to positively locate the stud.
Any suggestions on how I can piece together a new set of custom links?
I installed a new detroit speed swaybar into the front of my 4thgen camaro. Im getting ready to install Coleman hubs and swap the front bushings for poly as well. Apparently, the bar was not made considering I might be using brackets to upgrade my front brakes because it causes a serious interference problem.
While it appears that I could bring out the grinder to modify the bracket and swaybar to fit better, I think a better solution would be to use a longer endlink...If I webt 1 1/2 inches longer there would be no problem.
This is an adjustable bar...it uses c5 style end links. It uses the flats cut into the end to positively locate the stud.
Any suggestions on how I can piece together a new set of custom links?