Gibbles
Clicker of buttons
Well today I'm picking up a new project...
It's a 1989 winnebago class c motorhome, sitting on a ford econoline chassis.
Powerplant is a ford 460 bb...
Story behind this project, this belonged to my family, it had some water intrusion in the roof that caused the rear inside roof to collapse.
I think that part will be somewhat straight forward, however the fiberglass paneling on the sides has delamination to the point where i think it's best if i fully remove it to ensure all damage can be assessed.
Good opportunity for a color change as well.
I have an air system i put together in order to paint the vette (quincy qt54 2 stage, and about 100 feet of air system to cool and dry the air), and a 3m accuspray gun setup that i need practice using before i decide if it will get the vette painting job.
The hardest part of this project i think will be the replacement of the fiberglass sheeting on the sides since I'm not finding much on the actual replacement procedure...
It's a 1989 winnebago class c motorhome, sitting on a ford econoline chassis.
Powerplant is a ford 460 bb...
Story behind this project, this belonged to my family, it had some water intrusion in the roof that caused the rear inside roof to collapse.
I think that part will be somewhat straight forward, however the fiberglass paneling on the sides has delamination to the point where i think it's best if i fully remove it to ensure all damage can be assessed.
Good opportunity for a color change as well.
I have an air system i put together in order to paint the vette (quincy qt54 2 stage, and about 100 feet of air system to cool and dry the air), and a 3m accuspray gun setup that i need practice using before i decide if it will get the vette painting job.
The hardest part of this project i think will be the replacement of the fiberglass sheeting on the sides since I'm not finding much on the actual replacement procedure...