I got board today and starting looking at my hydraulic roller lifters thought I’d inspect them since I have cam & distributor gear metal in my engine while I was inspecting I found that some of the pushrod cups would not move like the others (push in) so I soaked them for a while in hot soapy water then took them apart and cleaned out every part then put them together now they all move “freely†as they should, wanted to know if they still can be used??
The rollers all move freely to, but have some small scars on them don’t know if that would be a problem for the new cam going in, I’d like to save the money if I can and reuse them if every thinks it be ok?
The new cam has 550 lift is that a problem for these lifters?
you might see some lint in the pick, there all cleaned in the pics
The rollers all move freely to, but have some small scars on them don’t know if that would be a problem for the new cam going in, I’d like to save the money if I can and reuse them if every thinks it be ok?
The new cam has 550 lift is that a problem for these lifters?
you might see some lint in the pick, there all cleaned in the pics