Installed the CKP Billet Servo that applies the Intermediate Band, the piston
has a bigger area for fluid pressure to impinge on. This gives it a significantly
larger clamping force. It clamps down on the Direct Drum when applied and
stops it rotation.
Don't do what I did and try and straighten out the snap ring ends, the ends
are bent for a reason. Like they say, don't ask me how I know. I will show you
why they are bent. There is no reliefs for the both ends to extend out of the
snap ring groove, therefore the ends are bent towards the center. Otherwise
the end will hold the snap ring out of it's groove.
I know it look like there are two exit points for the snap ring, but they
are too far apart. So I only re-bent one end.
Last edited: